Simple car battery charger

Lead-acid battery chargerThis is about making a very simple charger for lead-acid batteries, commonly used in automobiles.

In case you can’t parse the picture, the setup is simple: mains power is connected to a variable autotransformer, then in series to a transformer, a diode bridge, an ammeter (not visible in the picture), and a battery. There are also capacitors and a voltmeter in parallel with the bridge’s output.

The purpose of each block is as follows:

  • the autotransformer is used to regulate voltage and current, simultaneously;
  • the transformer drops voltage;
  • the diode bridge rectifies AC;
  • capacitors smooth out the rectified waveform;
  • the ammeter and voltmeter are for monitoring;
  • the battery is the load.

I have no idea whatsoever what the exact parameters of each block are, except that most of them are big.

Both transformers’ wire windings should be thick enough to withstand the current pumped through them.

The step-down transformer should have a ratio such that it can drop mains voltage to a value slightly above the desired output voltage. This accounts for the voltage drop on the bridge and the fact that to charge a battery in reasonable time, a higher than rated voltage has to be applied.

Zap batteries!My diode bridge here is four individual diodes whose ratings are certainly overkill for the task. Voltage drop on the bridge is twice the drop on a single diode.

The caps are rated for 400V – that’s what I found in the bin. They can surely be quite smaller, but at least twice the maximum voltage.

The ammeter was also available in the bin. It’s analog, with a dial and a maximum value of 10 A. If you intend to use a multimeter as an ammeter, know that they might not have the appropriate circuitry inside, even if it’s on the dial. Also, there might be a cigarette butt instead of a fuse if a friend of yours blows it and decides to play a prank on you.

The voltmeter is an el-cheapo multimeter from the store. (EDIT: I eventually swapped that out for an analog voltmeter, so the multimeter could be used elsewhere.) Its range should be bigger than the charger’s maximum output voltage.

In desperate times, all of this can be done with just a voltage-down transformer and a diode bridge. Everything else is optional, if you’re careful. Otherwise, you’ll zap batteries, since 1925:

Stanley Stanley P2G7S Simple Start Lithium Battery Booster
Automotive Parts and Accessories (Stanley)
  • Patented Cold Start Intelligence and Up Charge Technology
  • Reverse Polarity protection
  • Connect two ways - directly to your car battery or plug into your vehicle s accessory outlet
  • 2.0 USB port
  • Emergency LED light
Extreme Max Extreme Max 1229.4000 Battery Buddy Intelligent 6V / 12V Battery Charger / Maintainer
Automotive Parts and Accessories (Extreme Max)
  • Designed for long-term off-season storage in all climates for boats, ATVs, PWCs, UTVs, motorcycles, cars and more
  • Four intelligent charging modes: Initialization, Bulk Charge, Absorption, and Float
  • Charges all large and small 6 and 12 Volt lead-acid and flooded or sealed maintenance-free batteries
  • 1-year warranty
  • *Note: Features a regulatory internal safety circuit, will not charge batteries with a voltage below 3 Volts.
AUKEY AUKEY Booster Cables, No Cable Clipping, Simple to Use for Car Cigarette Lighter & Jump Starter, 12V Cars only
Wireless (AUKEY)
  • Ideal for new driver and anyone who don t want to get their hands dirty with opening hook and clipping cables
  • Use the cable to charge other jump starter external batteries and check car battery voltage, for 12 V cars/van/truck/vehicles only
  • Essential car starter kit solution to safely and quickly charge stalled cars with dead batteries without even opening the hood. Also includes 12V jump starter functionality
  • Ultra-compact and lightweight for portability and easy glove box storage
  • Package Content: AUKEY PA-V7 car cigarette lighter starter kit, user manual, 24 Months worry-free warranty and friendly customer service
Sunway Solar Car Battery Trickle Charger Portable Solar Panel Battery Maintainer With Cigarette Lighter Plug Battery Clamp For Motorcycle Boat Marine Vehicle Snowmobile Watercraft RV 12V Battery
Automotive Parts and Accessories (Sunway Solar)
  • [Simple and Very Easy to Use]-The solar battery charger panel mounts easily to the windshield or dash and conveniently plugs into your car s 12 volt cigarette lighter!...
  • [1.5W Solar Panel]-Keep your 12V batteries topped up with this solar battery maintainer ,which helps to manage battery drain in all seasons. The 1.5W amorphous solar...
  • [Stronger and Durable]-Covered with Durable ABS plastic housing which is stronger. And it is IP44 weatherproof (splash proof).
  • [For Any Rechargeable 12V Battery]-This solar battery trickle charger is the eco-friendly way to maintain the charge of any car, truck, marine , motorcycles , tractors...
  • [Prevent Reverse Charging]- With build in blocking diode to prevent reverse charging. And with Blinking LED charge indicator when charging. And the solar charger...

Related posts: